1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.
  2. Hi Guest, welcome to the TES Community!

    Connect with like-minded education professionals and have your say on the issues that matter to you.

    Don't forget to look at the how to guide.

    Dismiss Notice

Roland Techsoft TS30

Discussion in 'Design and technology' started by blahblahblah, Sep 7, 2020.

  1. blahblahblah

    blahblahblah New commenter

    Hi everyone

    I wonder if anyone on here who can help me? My school has been gifted a Techsoft TS30 and I wondered what software and drivers I would need to get it to work? Can anyone advise me what and where to get them from please?

    Thanks

    Jeff
     
  2. Ostroc

    Ostroc New commenter

    You can use 2d designer, the colours can represent the depth of each cut

    Regards

    Jez
     
  3. Jeff,

    A few years ago, I had the same issue at my school but after a few months of searching the web I was able to find the drivers! Like Jez said, the engraver can be used with 2D Design but it will NOT work without the drivers installed on the machine. Believe me, I've tried. Drop me an email at tgosborn@outlook.com and I am more than happy to send the drivers over to you and provide you with any other assistance you may need.

    Regards,
    Tom
     

Share This Page