1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.
  2. Hi Guest, welcome to the TES Community!

    Connect with like-minded education professionals and have your say on the issues that matter to you.

    Don't forget to look at the how to guide.

    Dismiss Notice

Making Casings for electronic products

Discussion in 'Design and technology' started by remyk69, May 12, 2011.

  1. Drain pipe is proving very useful. Buy a length of the square section from B&Q, it is about 66mm square. Cut off lengths of about 50mm and you have a basic enclosure. Several ways to make a base and a top. You can also cut a slot which is 3mm wide and slide acrylic into it.


Share This Page